TAM!! [for the time being in German - sry folks, it's kinda a matter of time]
One thing first: This is not a traditionally manual for correct original Japanese Kimono. Even the pattern is simplified and not original.
You need:
- material for yukata (summer kimono-home): the best cotton, linen, or similar substances that do not throw many wrinkles and rather stiff; for Kimono : satin, silk or cotton to each sample, NO! Gloss satin or silk, carnival, absolute no-go for kimono (and for Other Cosplay, by the way -.-) -
sewing machine would be an advantage
- Iron
may or may not be
-
tape
how it works:)
First of all you need dimensions.
Where exactly is your As and Bs, etc are must, define their own - just where it is proportional terms the best looks (I know this is very vague and not exactly very traditional v__v)
a point is established and that is E , the kimono hem, which is namely in the ankle. For the other points you just look a few times Kimono pictures;)
must measure following her
- from A (middle of the neck) to B
- E to F
- from B to E - from B to C
- from B to D and multiply by 2
- it also needs the collar-length (blue mark) - that even from the front around your neck around to the front again measure
to any measure you should now add 4 cm seam allowance. can use these measurements to cut out their fabric pieces now (rectangles) in a sketch arrange such that it consumes as little material.
Remember, prior to multiply the distance BD.

- 2x the rectangle AB x BE = 2 backs
- 2 x EF x BE = 2 breast pieces
- 2x BD x BC = 2 sleeve
- 1x collar length x 14cm = collar
After cutting you go even to the sewing ^ ^
please note: I patterned fabric used on the left (= inside) is white - you can detect always good, what is inside and what outside.
Spread the two backs ahead of you, and then puts them together:
plugged the line AB (on the right side, where there's also been characterized) with pins and sew one long set.
A "Blitz seam" does better than a simple suture. Look, if you can find in your sewing this seam-type, if not, then at least a double seam due (ie a second time to sew the route).
(click to enlarge the image) Sets the matter again before you. Now, the two breast pieces (left and right) to
(pictured, all parts are equal, let yourself confuse them not, I used to date another pattern = bad choice) flap breast parts of the pages from the inside.
(click to enlarge the image)
The segment AB is again stuck with pins and is to be sewn. Observed but before that their agents from the seam (in red circle) starting sewn together on each side about 10cm NOT. This is your neck and if the later are 10cm too narrow, you can unravel the still (what is ertseinmal better than too much neck, because you may slip from the shoulders of the kimono). You can check the neck before, when her kimono "try on"
what probably is an over throw first ^ ^
Also at this point, the "flash seam" on. Spread the kimono once more before you, and specifies the sleeve parts on both sides as follows. (The yellow line marks the center)
From A to B is again pinned.

red mark: Before you sew AB, puts the matter only once as shown in the figure set (turn once and fixed with needles).
on both sides, please; top and bottom.
(click to enlarge the image)
Now you can both arms, from A to B Sew (flash seam). Kimono spread:

from A to B and C of
stuck to D (each on both sides, of course)
-> the routes Sew by lightning seam to prevent fraying of the suture
red circle mark: I would recommend you, not with the machine until it stops to sew, but leaving a small opening and then by hand from right to sew (= outside), otherwise possibly arise unsightly wrinkles.
Next, they are hemmed sleeve openings. Turning to the kimono on the right (= outer side out, so how would it attract too) and take you from the sleeve opening.
Beat the edge at once.
Beat him for a second time and fixed him with pins.
the fixed sleeves with a normal seam sew.
Now you you should wear the kimono and determine whether the extent to which the fabric pieces are on the front of each other. If you this is too much material up front (varies depending on waist size), and if you can tweak a little.

The kimono should be like in the picture above the other.
lines the line AB, as you have the sleeves hemmed (2x = turn).
Both
line fronts, ne;)

The collar:
Spread the flap of the collar on an ironing board from
it folds in half and ironed over it.
(click to enlarge the image)
Spread the collar again. Now you will collapse the bottom so far up that the collar half below the center fold is about 6cm wide. (See photo) (click to enlarge the image)
press the section.
(click to enlarge the image)
power the entire length of the collar, always turn down a section, measure and fix by ironing. After you've done that, the upper collar half folded down.
Sets the excess fabric of the overlying collar half to the inside (see photos) and fixed the whole thing by iron.
With the two ends of the collar should you proceed as follows: fix iron + by.
sew on the collar:
(And again lurks confusion danger. I'm here now a black collar on the photos, but this has to mean no more Just keep going ^ ^)
Marks the longitudinal center of the collar with a pin or tailor's chalk and spreads and kimono collar so Imagine this:

(The open side of the collar facing down)
the kimono fabric sets about 5cm into the collar. (The center of the entire kimono exactly in the longitudinal center of the collar)
(click to enlarge the image)
(The dotted line marks where the collar runs underneath the kimono) and with fold out
a safety pin stuck:)
Works you in this way, each on both sides of the center until the points A and B. could at points A and B, with the net exposure of the kimono fabric in the neck are a bit short, but that is normal. As long as the kimono still mind extends about 1.5cm in the collar, everything is ok.
Sets the collar loose forward. Something like (black arrow) should the collar be:
The excess fabric corner (blue arrow) is EGTL disappear in the collar, But you can cut off even if the tip is too big:
(to enlarge Click on the picture)
on the principle "collar wraps kimono fabric", you put on the kimono Vorderdeite of the fabric in the collar:
Make sure that the collar-end finishes clean on a line with the kimono-Rand.
When putting on the collar you have
extremly be careful, that is best for a needle set to the next, so it is infected as smooth as possible, otherwise occur when sewing with the machine evil folds and shifts, which is really nothing around solemnly.
Smoothing Always nice everything. If you this is successful, is only the hem (bottom of the kimono, to your ankles) from. Lined him as it the sleeve openings have missed (turn = 2x) and you are
..
OMG ..
done.

I really hope this was understandable and tutors has helped you or will you be beneficial.
Good luck and have fun in your kimono / yukata:)